PDA

View Full Version : Need help modding a DC Agetec stick



yeton
November 19th, 2005, 14:51
Hi, I'm trying to rewire one of my old DC sticks to use on my PS2 (works outa lot cheaper than buying a RAP!), but I'm a bit stumped by the wiring for the circuit board directly below the stick itself (not the main board located beneath the VMU slot). I see five wires coming out of the left of the stick's board going to the main board, coloured (in this order):

1) yellow
2) orange
3) red
4) brown
5) black

I'm assuming the black wire is the ground. I was wondering, which wire corresponds to which direction on the stick, as I'm having extreme difficulty in figuring it out! :(

Many, many thanks in advance!

kingbuzzo
November 19th, 2005, 15:01
I tried wiring to the pcb with no luck as well.

Splicing the wires works a whole lot better.

Can't find which wire is which? It's actualy clearly mapped on the pcb if you follow it

here's what I wrote from my past project.

Joystick:
yellow.........left
orange........down
red.............right
brown.........up
Black..........Black

good luck,

King.

yeton
November 20th, 2005, 17:26
Thanks, it was stumping!