wraggster
December 26th, 2012, 00:35
http://hackadaycom.files.wordpress.com/2012/12/original-arcade-pong-rebuild.jpg?w=580&h=435
This heavily populated PCB is a recreation of the original arcade version of Pong (http://imgur.com/a/TUGto/layout/blog). That is an important distinction because the home version of Pong used a specialized chip to do much of the work. This is basically all stock logic, which explains the high component count. We wonder how many quarters it took just to pay for all 66 chips at the time?
[Pong74ls] was the person who took on this project. There is an original schematic available, but it’s incredibly crowded and rather difficult to figure out. Fortunately [Dan Boris] has already done a lot of the heavy work. He took the one-page nightmare and turned it intoa sixteen page plan for building the original board (http://atarihq.com/danb/Pong.shtml) (look for the schematic link under technical details).
Before the board could be laid out some redesign work was necessary. It sounds like some of the original chips are out of production and suitable replacements needed to be found. The board was then laid out in Eagle before sending the design off to a fab house. There was just one error which didn’t allow the ball to bounce when hitting a paddle while travelling downward. A couple of jumper wires fixed that right up!
http://hackaday.com/2012/12/22/fabricating-hardware-from-the-original-arcade-pong-schematics/
This heavily populated PCB is a recreation of the original arcade version of Pong (http://imgur.com/a/TUGto/layout/blog). That is an important distinction because the home version of Pong used a specialized chip to do much of the work. This is basically all stock logic, which explains the high component count. We wonder how many quarters it took just to pay for all 66 chips at the time?
[Pong74ls] was the person who took on this project. There is an original schematic available, but it’s incredibly crowded and rather difficult to figure out. Fortunately [Dan Boris] has already done a lot of the heavy work. He took the one-page nightmare and turned it intoa sixteen page plan for building the original board (http://atarihq.com/danb/Pong.shtml) (look for the schematic link under technical details).
Before the board could be laid out some redesign work was necessary. It sounds like some of the original chips are out of production and suitable replacements needed to be found. The board was then laid out in Eagle before sending the design off to a fab house. There was just one error which didn’t allow the ball to bounce when hitting a paddle while travelling downward. A couple of jumper wires fixed that right up!
http://hackaday.com/2012/12/22/fabricating-hardware-from-the-original-arcade-pong-schematics/