UMD drive starting when no UMD is in the slot.

Printable View

July 13th, 2007, 05:52
jamotto

UMD drive starting when no UMD is in the slot.

Ok, I have a psp (TA-082) that has had the following OFW versions 2.80,3.03 and now 3.50. My problem started when I upgraded from 3.03 to 3.50.

The issue is that whenever there is no UMD in the slot, at some random time could be after a few seconds or it could be hours later, the drive will startup and proceed to run the laser up and down the slide rail, when it reaches what would be the start of the UMD it clicks about a half a dozen times and the whole process starts over again. It will continue doing this until I insert a UMD, it then stops.

UMD drive works, it will play every game or movie UMD I put in it, and as long as I have a UMD in the drive the above mentioned problem never occurs. I've googled this for at least a week now with no luck at finding a reason as to why it occurs or a possible solution to fix it.

I've already tried the Restore Default Settings with no luck. I don't think the disc detector switch is going bad, as that should turn the laser on, which is not the case here.

So if anyone here has any suggestions, I'm all ears.

Thanks in advance
July 13th, 2007, 06:45
cataphrax

Hmmmm, I'm completely unsure except that you could just keep a disc in it at all times.
July 13th, 2007, 15:29
jamotto

Yep, that's what I have been doing so far, I was just looking for a different solution, perhaps one that wasn't as much as a bubble gum fix as this.

Could be just a bad firmware update I suppose.
July 13th, 2007, 16:16
pt9087

Open your UMD drive... there are two silver screws... make sure they are tight to the PSP.
July 13th, 2007, 16:33
Xiofire

If you look inside the PSP's UMD Slot without a UMD In it, you should see a tiny piece of black plastic sticking out. This is the laser activation swith, and if held in, will do what yew have described. See if that black plastic is stuck, and if so, "unstick" it. All i can suggest.
-Xiofire

EDIT: My bad, just read your comment about the laser switch. No idea then, Id suggest what pt9087 said.
July 15th, 2007, 07:12
jamotto

Quote:

Originally Posted by pt9087

Open your UMD drive... there are two silver screws... make sure they are tight to the PSP.

I checked them and they were good and tight.
July 15th, 2007, 07:21
xg917

when did you start noticing this problem? edit: sorry i didnt read the first post that well. um.. well yea my suggestion is the only suggestion i have since everyone else told you what i was going to say

maybe downgrading will fix the problem?
July 15th, 2007, 18:00
jamotto

Quote:

Originally Posted by xg917

maybe downgrading will fix the problem?

I removed the UMD and tried the downgrade, doesn't seem to help unfortunately. Oddly enough the drive had the same issue during the entire duration of the downgrade, I figured that it might stop during the downgrade, but that was not the case.