DosFlash V1.3 Beta - Full Software Based BenQ Flashing

Via xboxscene

As of right now, only nforce and VIA chipsets are supported in 100% software read/write of the BenQ drive with DosFlash(info). Success varies dependent upon which motherboard you have (intel (ICH) seems to be problematic combined with VIA)

- BenQ optimization in unlocking the flash chip, it should now be possible to read/write/erase the flash without any soldering or wire tricks, the drive is polled for the correct mtk unlocking status after power on, this only works for VIA cards and NForce boards atm
- DosFlash32 has one additional parameter, if you start it with the parameter "EnableDrives" all the DVD-ROMs are enabled in device manager after flashing, this could give BSOD on some systems, therefor you need to create a DosFlash32 link and add that parameter manual to use it
- DosFlash16 has one additional parameter "Send ATAPI Device Reset" in manual mode, this could give better chances for soft flashing on some VIA - motherboard combinations
- better support of Intel chipsets, drives can now be flashed if the controller is not set to native mode in the BIOS
- the following controller list includes vendor and device IDs that are hardcoded to identify the controller type (IDE or SATA), this is needed if the BIOS uses IDE ports like 0x01F0 or 0x0170 as SATA and not as IDE channels, this list is NOT related to soft flashing

NOTE: This is a *BETA*. It is being released to help fix any problems within the program, and to hopefully increase compatibility. Your *constructive* feedback is wanted! So please post in either the XBH or the X-S threads below with your success/failure and specific steps. Use at your own risk!!!

Also, there is NO 'xtreme' firmwares for this drive yet, so as of right now this tool is only useful for getting your key, and using a different drive as a replacement. ixtreme for benq is nearly complete, and in testing stages. No ETA given for release.