More information on the Leaked official Sony PSP Unbricker

Yesterday it was reported that Sony's special PSP memory software was leaked onto the web, and in conjunction with a special battery had the abilility to unrbick PSPs. We sought some more information on what this magical software/hardware combination can do and found out a few interesting facts. The software is used only at official Sony factories, and requires the use of a special battery which enables Sony to unbrick a PSP when both software and the respective hardware is present. The battery is used to initialise the PSP service mode and once this is active the kernel on the memory stick runs.

DIGG THIS



[via EvolveXMB]

interesting isn't it????? i wonder if a person could hold both???

interesting

Just need to find a near sony factory to me and I buy have to buy a new crowbar

This information is pretty much the same as what was in the last post about this but this is still pretty cool. I wish I had one of these to sell the services of it and unbrick other peoples PSP's.

Somebody needs to lift one of those batteries,
then maybe reverse engineer it or clone it or something.

The advantages of having this work, and being something people could build would be endless.

That would also mean Sony lost the war completely.

Quote:

---

Originally Posted by mavsman4457

This information is pretty much the same as what was in the last post about this but this is still pretty cool. I wish I had one of these to sell the services of it and unbrick other peoples PSP's.

---

Same here.

It would be fun to work at one of those just to see what exactly they do.

Quote:

---

Originally Posted by ExcruciationX

Same here.

It would be fun to work at one of those just to see what exactly they do.

---

You should try to get a job at the main Sony place then "borrow" an unbricking battery, and take it to someone to get them copied.

Yeh this being leaked out would make us Win The War On Sony.

^ ^
I like that

Hmm wow i bet that battery is gold!

Can this reflash any fw?

What they are calling a battery sounds like a self powered eeprom flasher that contains the IPL microcode necessary to flash the psp eeprom with a special recovery firmware.

Why couldn't the same thing be accomplished with a Devolution chip?

It could, people just aren't smart enough to install it.

Smart probably doesn't have a lot to do with it.
More like steady hands, skill and the right equipment.

What makes this "battery" any less difficult to use.
Why couldn't a chip like the devolution be adapted to use the same technique especially *if* its easier to use...
ie less install points, sanding and so on.

This battery I presume holds kernel access to the firmware. Thus launching the prx's in the file which then must launch the PSAR file and flashes the firmware to whatever the PSAR update is

I see... the devolution does not contain any Sony IPL
Which is what makes it "legal"
So less solder/contact points I assume...

Develotion just contains another flash onboard thats how they restore the corrupt flash

true true... probably a 3rd party unbrickerss????

what lies on this little chip that does the wonders? hmm...


http://www.acidmods.com/tutorials/images/btm5.JPG
http://www.acidmods.com/tutorials/images/btm6.JPG

(images above taken from PSP AAA battery mod at acidmods.com)
http://www.acidmods.com/Wiki/tiki-in...0by%20-Neubit-

There the original battery's I dont they have anything on them Sony are not that stupid to leave something like kernel access on them

Quote:

---

Originally Posted by splodger15

There the original battery's I dont they have anything on them Sony are not that stupid to leave something like kernel access on them

---

or ARE THEY!? lol

They make mistakes all the time.

here me out, I'm not skilled in this department but I bet acidmods, n00bz, or dax could figure this out.

The so called golden battery has a 4th pin that is used during the flashing, so couldnt they make a usb cable the has connectors to all the pins the batter hits? so the psp would be charged via the usb cable and hit that pin allowing an reverse enginneered program running on the pc to do the rest? we have the software so that should tell us how it does it right?

I think we wont get a official copy of the battery but we will get a clone of one that someone has made.

Only problem is how much are they going to charge for this

I dont believe this to be honest.

I will believe it when i see it.

I think this is quite real all the files I have seen in the folder seem (cushty) to me.

FYI many 'versions' of this have been leaked before, this just happens to be an earlier version which flashes a lower firmware than the others.

My theory on how this could open up many doors in the future is that we could purposely brick PSP's with 3.10 and above firmware and then use this to unbrick and install 1.50 firmware. Then we could upgrade to 3.xx OE firmware from Dark_AleX.

Does this make sense?

If that would work, how would you brick a PSP with official SONY firmware?

^ ^
Well update pull the battery out and you have a brick

WOW, this thread is filled with so much garbage, I'm debating posting actual information here. The OP is accurate, but the assumptions that everyone is making are just LUDICRIS.

1. There are only _THREE_ pins in the battery compartment. Not four. One is a positive contact, one is a negative contact, and the third is a serial link directly to the PSP's bus.

2. This 'battery' everyone is referring to is not a battery at all. Sure it provides power, but it is a base station that you will not get your hands on. The base station is capable of emulating all of the PSP hardware that exists before the Bus hitch at the battery. This means that the station can initialize all of the hardware within a bricked PSP. Essentially they use a second psp to boot the first.

Think of it like this:
You have a motherboard with a bad CMOS.

You boot a working, identical motherboard into a CMOS flasher, pop out the working board's CMOS, and pop in the corrupted CMOS to flash.

You use another machine's hardware to write to the first machine's memory.

So the conclusion to all of this? It's a worthless post, and a worthless piece of software. Why do you think Sony cares so little that this software got leaked?

Because it will not help anyone unbrick a PSP. You NEED the base station or this software does NOTHING.

The 'unbrick' trick does NOT lie in the leaked software. The trick is the ability of the base station to initialize all of a bricked PSP's hardware so you can write to the flash.

Quote:

---

Originally Posted by splodger15

^ ^
Well update pull the battery out and you have a brick

---

but if you have it, then you can un-brick it :thumbup:


and this "Base Station" sounds a little more correct than an actual battery

i need to go steal one of these and sell it on ebay for 1000000000 dollars

If i had one of those things i would buy tons of bricked PSP's of the internet and then unbrick them and sell them for more money.

Quote:

---

Originally Posted by zoson

The 'unbrick' trick does NOT lie in the leaked software. The trick is the ability of the base station to initialize all of a bricked PSP's hardware so you can write to the flash.[/B]

---

^ ^
Most people in the PSP scene had known that already. There is assumptions the "Jigkick" battery contains kernel access then it runs these leaked files.

This software is launched when the battery is implemented

If i had this batery i would sell it!

if this "battery" (base station) gets out with the software, ill be VERY happy :D :cool:

Quote:

---

Originally Posted by Buddy4point0

i need to go steal one of these and sell it on ebay for 1000000000 dollars

---

No even better, get the whole homebr3w community to raid sony factories worldwide emptying out all these base stations.

Downgraded version 1.5 PSP's for everyone !!.

Bit dodgy! Reading some of you ladies comments made me think... False

Quote:

---

Originally Posted by wty4ka

it appears that the bottom three pins all do the same thing as they would still be semi hidden behind the warranty label so they need 3 pins(RED CIRCLE) to confirm the connection
the other pin seems to come from the yellow power socket(PINK CIRCLE) not sure whether it is +v or -v but it seems that you just short these holes as with the NDS flash process

http://i132.photobucket.com/albums/q...pwrswboard.jpg
http://i132.photobucket.com/albums/q16/wty4ka/336.jpg

(All of this is speculation its not my fault if you try it and brake something further)

---

I found this on another site. I think there is no special battery, but you first need to do something to these pins, then load the "special memory stick".
And the board DOES connect directly to the motherboard.

Isn't that hinting something? What could be so special about a battery. Like I understand the use of software to unbrick but a battery? I had a PSP sent back around March this year and when I got it back, there was a new face plate on it so I thought the motherborad got replaced or something until now when I look to c if its a TA something. This is interesting news.

I heard that sometimes Sony gives you back a different used psp.

like the Refurbished 1.5s? i've seen them around...lol. In fact, some of them are still bricked xD