harley g's recovery mode help

[ICE]

i just installed harley g's custom firmware and i dont have a clue how to use recovery mode. can anyone tell me what i need to do to use it in case i brick my psp later. thanks in advance.

[Kramer]

Did you even read the manual or read me
im sure your question will be answered in it

[ICE]

no its not in there. im not that dumb............... it just explains how to boot in the 3 different modes. config. 1.5 and devhook.

[Kramer]

maybe it's config mode I dont know I dont have HarleyG custom firmware but I think you flick the wifi button up or down. or it might be put the power button into hold while the psp boots up.

[bullhead]

Im still a bit iffy on that subject of the custom firmware. I dont know the specifics. The readme was a bit technical when i downloaded it, so could do with some explaining.
I know to have the hold switch down, but thats all...

[ICE]

i go to config then down to recovery menu and it gives me 5 options: Flash ms0:/index.dat to flash0, flash ms0:/recovery.elf to flash0, flash ms0:/vshmain.prx to flash0, start update eboot, and remove cuatom firmware( i know thats not it................)

[Kramer]

i go to config then down to recovery menu and it gives me 5 options: Flash ms0:/index.dat to flash0, flash ms0:/recovery.elf to flash0, flash ms0:/vshmain.prx to flash0, start update eboot, and remove cuatom firmware( i know thats not it................)

yeah that's the recovery menu if you brick you put a 2.00 update in a folder called UPDATE inside GAME on your memstick then run "start update eboot".

[ICE]

so if it dies can i put any update(ie. 1.5, 2.0 or whatever) into the update folder and then go to "start update"?

[Kramer]

no only an update higher than 1.5.

[ICE]

ok thanks man any clue as to what the other crap is? it might be useful to know later.

oh and if i do brick this thing then how can it still boot to configuration mode to run the update?