
Originally Posted by
kando
ok, here is how u fix an analog stick that is cracking, turning, or stopping halfway down the circle. i have attached pictures to go along with this, they follow the order in which i will explain.
first, open up the psp. take off the faceplate, and put the rest of the psp on the side as you wont be doing anything to that.
unscrew the 2 screws that hold the analog stick in. so now, you have just the analog stick by itself.
on the back, there is a metal clasp, which is held by 2 notches on each side of the analog stick (see below picture). carefully use a flathead and pop the metal holder off by popping each of the four locks out from the side. once done, take off the metal piece.
now, the green circuit board comes off very easily from the rest of the analog stick. it is held down by 4 pieces of plastic which do not unscrew or move...simply wiggle it out. remember which way the contacts are facing!
now, there are 3 pieces of plastic on the inside. following my pictures below, re-place them inside the analog stick, making sure the center of each is lined up with the stick protruding through the center. also note where the gold contacts are on the remaining 2 pieces of plastic in the picture below.
you can test your analog stick before putting it all back together by holding the plastic pieces with your thumb and just making sure that the analog stick is correctly moving all of the pieces inside of it.
once thats good, put the green board back on, put the metal back on, screw it back into the faceplate and close it up!
should be fixed!
again, check the pics i attached!
hope this helps ^_^
Bookmarks