Mapthis 0.5 and Holux m1000 sound?

[mr7]

I cut the head of plug .

And it's possible to use the psp speakers with a gps .

[in7ane]

Yes, I can confirm that this works - thanks!

[r2000]

I did not want to cut it.
It is nice to know the option.

[PDG]

I did not want to cut it.
It is nice to know the option.

Hmmm cutting the tip off seams a bit harsh, wouldnt it be easier just to disable it by desolder the cable at the base ??

[deniska]

Hmmm cutting the tip off seams a bit harsh, wouldnt it be easier just to disable it by desolder the cable at the base ??

This would not work..

[mr7]

Pics Of Jack。
So ，must Be Cut The Plug。

[mr7]

keep in disconnected mode, A -a (B-b).
but not the wires.

[lofarkas]

Well, if you want to refrain from violence you can try sealing the tip with nail polish or some clearcoat or another. It either works or it doesn't, acetone reverses the situation either way.

[PDG]

keep in disconnected mode, A -a (B-b).
but not the wires.

Im not an evil genious but i think i can remember my electronics, and im still confused and beleve that if you desolder the a2 at the base that would be the same as "cutting it off"...



A goes to a + a2 further up = Left
B goes to b = Right
C goes to c = Ground

Disconnecting the wire from a2 disables both A + a on the connector leaving B+b and C+c intact.
B for Right channel sound and C for Ground.

Or did i get to little sleep last night too

[chi80]

Hi PDG,
This is not an electronic switch, but a mechanical switches.
There is a machanical switch at A for PSP speaker.
So it's no use that you cut the cable.

you need to cut the "a", and the stick would be shorter. After that, it can't touch the swich, so PSP speaker could work then....